Screw top containers with width no more than 17 cm (7") and length no more than
25 cm (10"), minimum base measurement of 50 mm (2"). The height must be no more
than 35 cm (14") and no less than 7 cm (3"). The machine may be modified for
larger containers at an additional charge.
The machine includes a spindle cap tightener which requires caps to be the highest point on
the container and the cap must be wider than any handle.
Standard machines may be used for metal or plastic caps from 18 mm to 58 mm. Cap chutes are easily changed for different cap sizes. Special machines may be constructed for larger caps. The machine is also capable of closing "snap" caps.
The machine "flow" speed is adjustable to match the speed of the conveyor (supplied separately). Maximum speed is 9 m (30 ft.)/min. The machine will accept randomly spaced containers. Typical maximum speeds are as follows.
| Container Size | Round 1 Liter/1 Qt. | 100 |
|---|---|
| 'F' 1-Liter/1 Qt. | 80 |
| Round 4 liter/1 gal. | 60 |
| 'F' 4 liter/1 gal. | 50 |
The bottles enter the machine and the caps are automatically placed on the bottles. The bottles proceed to the cap tightening section where the cap is held down with a chain that is synchronized with the conveyor. The container is held by two belts that are also synchronized with the conveyor. The bottle cap passes through 4 sets of rotating spindles that contact the sides of the caps and spin the cap tight. After tightening, the capped bottles exit the machine on the conveyor.
A worker must regularly refill the cap hopper which has the cap supply.
The machine is shipped assembled and is capable of being installed by plant
personnel. The machine must be connected to a 110-120 v/60 hz/1 phase electrical
source.
The machine is designed to be placed over an existing conveyor and the speeds
of the holding belts are adjustable to meet the speed of the conveyor.
The CIB-104-HC model includes its own conveyor if no conveyor is available, or a
separate conveyor may be purchased.
When the container is changed, the height of the closing assembly is adjusted using the height adjustment motor. If the cap size is changed, the width of the guide bands and positions of the spindles are adjusted using adjustment knobs.
The machine is designed to provide the user with long service
and minimal maintenance. The standard frame is a tough welded
steel with an industrial coating. All parts in contact with the cap are
stainless steel or plastic to prevent corrosion.
The machine includes an illustrated operation/maintenance manual.
The machine is designed for independent operation and there are no large external moving parts.
The A level is less than 20 db.
Electric: Two machine requires approximately 20 amps during operation.
115v./60 hz/1 phase.
Pneumatic: None
None for operation. A worker must, periodically, refill the cap hopper.
‘H" Frame and Casters: This permits easier movement from one capping line to another. Stainless Steel Frame: For use in corrosive or food applications.
122 cm x 122 cm (48"x 48").
150 cm x 150 cm x 210 cm (60" x 60" x 84").
900 kg (1550 lbs.).
HOME BACK TO CAPPERS REQUEST INFORMATION